By Rich

There’s nothing more cozy and peaceful on earth than sitting below decks on a boat and listening to a steady rain drum overhead. By a country mile my fondest childhood memories of cruising on our family Pearson 40 were of such moments.

As an adult responsible for maintaining our boat, there’s nothing that can obliterate the magic of those same moments more comprehensively than indignity of having to strategically place one or more salad bowls to protect nice cushions or teak from a leak. Between this past summer living aboard in Newport and this winter working down the resulting “to do” list, I can provide our dear readers with a comprehensive troubleshooting guide for deck hatch leaks. Continue reading Leaking Deck Hatches? Here Are Some Troubleshooting Tips →

By Rich

Among the rules of installing water, fuel, or waste tanks on a boat is the Golden Rule: marine tanks must be installed in such a manner that no significant forces act upon the tanks’ fittings. Let me say that again, in case it wasn’t entirely clear:

Marine tanks must be installed in such a manner that no significant forces act upon the tanks’ fittings. Continue reading How Not To Install A Holding Tank →

By Rich

It’s vital for centerboard boat owners and crews to be fully aware of the location and nature of all components below the waterline – and for these components to be inspected regularly. Last summer when we hauled out to replace our broken centerboard cable, we got a look for the first time at the sheave box for the cable in the lazarette (pictured above) when it was removed as part of the cable replacement. Those brown streaks mean that some parts of the box had rusted completely through and begun to leak through pinholes – not good news given that this component lives below the water line! The rust wasn’t serious enough to be a risk to the boat in the immediate future, so we re installed it and made a note to remove it and have it repaired over the winter. I also noticed that a small section of rubber hose served as a coupler between the sheave box and the rest of the cable conduit, which is stainless steel. Though it was certainly due for replacement, the coupler didn’t look to be unsafe. Still, having seen both lazarette components I made a mental note for the coming winter to inspect the second (forward) sheave box where the cable exits the hull and its rubber coupler.  Continue reading Centerboard Boat? How To Prevent Potentially Dangerous Leaks →

By Rich

Our 1989 Sabre 42 originally came with 3 Group 27 marine batteries weighing +/- 67 pounds each for a total of 200 pounds or so. They provided 180 amp hours of house capacity (from two batteries) or 270 total if you factor in the third engine battery as well (I am assuming one of the three was originally dedicated to the engine). A prior owner upgraded our boat to one Group 27 engine battery and two 4D House batteries. The upgrade was well meaning, bumping the dedicated house battery capacity to 420 amp hours while still reserving a dedicated Group 27 for the engine. The downside was that the upgrade increased the total battery weight from 200 pounds to 331.

Continue reading Considering A Battery Upgrade? Factor In The Change In Weight →